EVA2 - Electric Audi A2
July 17, 2015
A whole lot of cables
›
Today I installed a thick bunch of cables between the driver footwell and the engine compartment. In the footwell is the EVCU, or controller...
5 comments:
July 10, 2015
Emergency STOP and TP cable for display
›
I am using a small LCD display to show the status of the Arduino EVCU and up to now I have used a soldered wire between the Arduino and the ...
2 comments:
July 9, 2015
Preparations for the fuel gauge
›
I want to be able to display the charge level on the Audi A2 fuel gauge. In order to do that I have to be able mimic the tank level sensor. ...
5 comments:
July 8, 2015
Signed, sealed, delivered battery boxes
›
The fit between the battery boxes and the frame was not 100% so I had to seal the spaces with sealant. As can be seen in the image below the...
1 comment:
July 7, 2015
The project is on again - battery boxes mounted
›
At last some free time and the opportunity to continue the project. It has been a long winter with all work and no play ;) Actually I start...
1 comment:
October 13, 2014
Charger, heater and vacum mounted
›
This weekend I mounted the charger, the heater and the vacuum system. The Brusa charger hangs under the same aluminum U bar as the Soliton m...
6 comments:
September 28, 2014
Cables, cables, cables
›
This weekend was all about cables. I mounted the DC/DC on the front battery box and connected it to the hight voltage in the front connectio...
5 comments:
›
Home
View web version
